This design came out perfectly. Thank you very much!!
The tenon is about 0.3mm too narrow, resulting a poor fit over the holding ring. The bottom of the tenon fall off the mortise on the holding ring for about 1.6mm. The cut out on the other end for the ...
отлично получилось, минимальная обработка до товарного вида, настоящая нержавейка, прочность сомнений не вызывает
All features are within 0.4mm of spec. Arrived slightly wrapped. Due to a design error, the well in the center is too shallow for the 35mm Petri dish to sit in.
This came out wrong. Print came out 30.9cm long, when it should have been 30cm exactly. I'm guessing this is the designer's fault and not PCB Way considering the other prints on my order came out perf...
Perfect fabrication, smooth and quick delivered after 14 days! Stainless steel, threads: NPT 1/8'' and M30x2
Hi, We received these parts today and found that they are out of tolerance and some of them have pink on them. The length shown in the image is supposed to be 51.053 +-0.15mm(ISO 2768-1). I measured 1...
very nice, sharp cuts, and nice 90 deg bends
The welding surface and color looks great. 3mm thickness steel might be a little too heavy for the project.
Print is good, there are no warps and no defects visible.
Display bezel made from UTR8220 Resin, with inserts. I'm highly satisfyed with the quality and a bit surprised, how stiff that material is. I painted it black with Acrylic paint.
Perfect fabrication, smooth and quick delivered after 14 days! Stainless steel, M30x2 thread
Excellent work! exactly as requested, I'm really happy :) Aluminum 5052, Sanding 500, Power Coat PANTONE 433U No tighter tolerances required (ISO 2768-1) Standard Inspection (No paper report) F...
Good
not much to mess up here, or one would think. perfect resemblance to sldprt file
Pressure sensor crimping die
1 ... 3 4 5 6 7 8 9 10 11 12 13 ...